Most Powerful Open Source ERP

How To Power On Your ORS

How To Power On Your ORS
  • Last Update:2022-01-26
  • Version:002
  • Language:en

Warning: Please do not plug or unplug the POE RJ45 cable from the ORS while injector is powered on.

  • To unplug ORS: Unplug the electrical cord between the POE injector and the electrical outlet, then the RJ45 POE
  • To plug ORS: plug RJ45 POE to the ORS, then plug POE injector to electrical outlet

Doing otherwise might break some electrical components inside the ORS. Even if the ORS has been manually powered off through SSH (for those having root access) you still need to follow this procedure to unplug it.

Prepare Waterproof Cable Mount Connector

Prepare the waterproof cable mount connector from your ORS package and a shielded Ethernet cable. 

Waterproof Cable Mount Connector

Split the connector to 4 parts. Note that C is inside of B.

Cut rubber ring C

Please have C cut as shown in the picture.
Note: cutting rubber ring C is in order to pass the Ethernet cable through. Instead of doing this, you can also make your Ethernet cable so the cable itself can go through the rubber without the RJ45 connector.  

Pass the cable

Pass the shielded Ethernet cable through D C B A in order. 

Connect parts

Connecting each part tightly as original.

Tighten the connector

Turn tight D so that there is no gap between shielded Ethernet cable and rubber ring C.

Plug power supply

You will find 2 interfaces on your adapter. Please plug your network ethernet cable to LAN and plug a shielded ethernet cable between POE and your ORS. After connecting the adapter to the socket, your ORS will be powered, and will emit a beep.

Install antennas

Assemble and install the two antennas as shown. The antennas should be vertically placed.

Note: The Rapid.Space antennas are just for test, you are supposed to purchase antennas suited to your requirements.